Made of folded sheet in the following option: aluminum, galvanized steel with or without powder coated paint or stainless steel. Junction plates legs-platform, anchor plates and reinforcement plates made in 3 mm (0.1181 in) thickness. Guides of the canvas in special anodized/lacquered aluminum profile with PET500, plastic material with a low coefficient of friction. The construction of the covers are polygonal with rounded edges and inclined lines to prevent the accumulation of dust. All materials used do not degrade while in contact with the environment or with cleaning or sanitizing agents. Curtain: It is a polyester resistant fabric and coated on both sides with a PVC sheet. Total thickness of the canvas: 2 mm (0.0787 in). It has the ability of both offering a low resistance to winding and high flexural strength. This feature makes it suitable to avoid the use of intermediate reinforcing bars, this is to improve the seal and to prevent the welding which generates irregularities in the surface thus creating areas difficult for cleaning or where you can have particle deposit. The tear strength is 5.5 N/mm width of the tissue. It can operate in a temperature range that extends from -28 ° C to +70 ° C (-18.4°F e 158°F). Offered in colors with anti-static. It is designed according cGMP standards and complies to FDA requirements. The socket consists of stainless steel folded plates with a neoprene gasket and its design gives excellent sealing performance at floor. The curtain with the edge guides design, allows the classification of the door according to EN12426 in class 2/3 with an air loss of 6/12 m3/m2 per hour (19.70 / 39,4 cu. ft per sq ft per hour). It is possible to work with values of differential pressure of 50 Pa (0.2008 in H2O) and it can withstand under test. Conditions up to 40 Pa (door of 1600x2100 mm). Based on the level of finishing and the selection of the materials, the door can be classified according to ISO14644 for clean rooms Class 8. Drive motor: The drum consists of an aluminum profile, mounted on a galvanized steel shaft 25.4 mm diameter (1 in) supplied with self-lubricating bearings. In the standard version, the motor-gear box has a nominal torque of 60 Nm to 180 rpm with inverter (frequency controller). Open speed: 1.50 m/sec (4.92 ft/sec). Upon request (optional), control panel can be supplied with an inverter in order to regulate the operating speed and acceleration. Torque force of 30 Nm to 180 rpm with parachute system, brake and encoder. Opening speed up to: 1.15 m/sec (3.65 ft/sec). Safety: The door can monitor the movement of the leaf with a continuous line of the light barriers which extend from the ground up to 2500 mm (8.2021 ft). If an obstacle is located in the way of the door, while closing, the leaf stops and reverses its movement. This is better and more reliable system than the combination of photocell and safety edge and avoid the contact of the leaf with the obstacle.
IN
